Suggested set-up:
Elevator: measured at trailing edge root: 12mm each way high; 9mm each way low.
Rudder: measured at base: 26mm each way high; 21mm each way low.
Aileron: measured at tip: 9mm each way high; 7mm each way low.
Flap as aileron measured at root: 6mm each way high; 4mm each way low.
Snapflap: measured at flap root: 7.5mm each way, worked out along the aileron to
maintain a straight trailing edge; my snapflap throw stays the same for high or low
rate elevator btw.
Camber: measured at flap root; 4mm each way, worked out along aileron to keep
trailing edge in line; elevator compensation 0.75mm each way.
Crow: Flaps at root 47mm down; ailerons at tip 4mm up; elevator 9mm down.
Enjoy!
Zim @
www.sloperacer.co.uk
