Wiring Loom
The loom route in the fuselage is under the rear of the tray, and then up where your
receiver is. Prepare the ports on the fuselage as shown below by removing all the
paint from the mating surface in the aperture. Then glue the mpx connectors in place
using thick CA (photos show the Typhoon fuselage but the install procedure for these
parts is the same).
Then, through the wing joiner hole, put some thickened epoxy onto the back of the
connectors to secure them really well.
Securing the wing-side can be done as an automating connection, but the simplest
way to do it is to simply leave the wing side loose and plug it on manually when
sliding the wing on.
It is wise to reinforce the solder connections on the wing side by gluing a small piece
of ply under the connections to the back of the mpx connector and then putting some
thickened epoxy onto the ply piece to cover all the connections and therefore secure
them.
