RCBS Pro Chucker 88915, Product Instructions

Page: 19 / 24

CASE FIT REFERENCE
Small Tube
Cartridges that fit into Shell plate: 12, 17 or 45
Medium Tube
Cartridges that fit into Shell Plate: 3, 6, 10, 11, 13, 16, 19, 23, 27, 32 or 39
Large Tube
Cartridges that fit into Shell Plate: 2, 4, 14, 18, 30, 35, 38, 43, 44, 48 or 49
TROUBLESHOOTING
It is necessary for your Pro Chucker to be mounted to a sturdy reloading bench. The Case Feeder sets the
cartridge case onto the feed rail and pushes it in. If there is a lot of “flex” or “wobble” to your reloading bench, the
cartridge case (particularly bottleneck rifle) may tip over. Add support/stiffeners to your bench or slow down the
loading rate. Backed out primers or damaged case heads can also lead to cases tipping over, inspect your cases
prior to starting the loading process.
If a case tips over and does not feed into the Shell Plate, you can manually insert the case. Push the handle back
so that the Shell Plate assembly is at its lowest position and hold there. Use the base of the case to push back the
Case Pusher assembly and then slide the case into the Shell Plate. The handle must be all the way back or the
Roller on the Case Pusher assembly will be stopped by the Flat Spring in the Cam Plate and will not move back.
If you force the Case Pusher assembly to the rear, you will most likely break the Flat Spring.
If more than one case is fed, the Top Stop Pin must be adjusted to add more “holding” pressure. See ADJUSTMENT
section 6.
The Lower Stop pin may also contribute to more than one case being fed if it is not engaged at the proper time.
Ensure that the Lower Stop Pin Close Cam is adjusted correctly. Refer to
ADJUSTMENT section 7
LUBRICATION
Periodic lube points on the Pro Chucker Case Feeder are as follows:
Light oil or grease
Top Stop Pin Shaft
Lower Stop Pin Shaft
Box Rail edges
Roller
Grease
Vertical Surface of Cam
17