6
Program for VCR—
Direct Entry Method
1. Manually turn on the VCR.
2. Locate the enclosed VCR Code List.
Find your brand of VCR.
Note:
If your brand isn’t listed, use one
of the Code Search methods to program
this remote control
(See
Code Search
on page 9).
3. Press and hold the
CODE SEARCH
key for approximately three seconds
until all four component keys light up.
Then release the
CODE SEARCH
key.
4. Press and release the
VCR
key.
The
VCR
key remains lit.
5. Use the number keys on the remote to
enter the first code listed for your brand.
After you enter a valid 3-digit code,
the component key light turns off.
Note:
If you enter an invalid code,
the lighted component key will flash
rapidly. Start over at step 3.
6. Aim the remote at the VCR. Press
the
ON•OFF
key. If your VCR turns
off, you have found the correct code.
7. Enter the code in the box provided
on this page for future reference.
8. If your VCR doesn’t turn off, repeat
steps 3-6 above, entering the next
code for your brand.
If none of the codes work or your
brand is not listed, use one of the
Code Search methods to program this
remote (See Code Search on page 9).
For a description of each key on
the remote control, refer to the Key
Descriptions section on page 3-4.
In order for the four component universal remote to control
your VCR, you must program it with the code that matches
your VCR. These instructions explain the preferred method
of programming the remote—the Direct Entry method.
ON•OFF
1
2
3
4
5
6
7
8
9
0
VCR CODE
CODE
SEARCH
RCU450_US_IB_REVA 10/22/03 9:02 Page 6
