11.
( ) DO NOT PLUG the unit into the AC Line.
( ) Turn the unit on by turning the "INTENS" KNOB clockwise.
( ) Check for a resistance of at least
80
across the AC line plug.
( ) Check for a resistance of at least 50KO from XV6-7 to ground.
If any resistance is smaller than the number specified, recheck the circuit.
FIGURE 17
1.
( ) Cut two 2-l/4" strips of the foam rubber supplied for both CRT CLAMPS. SECURE to the
CRT CLAMPS by pressing them onto the clamps as shown.
Detail of Foam Rubber Mounting
2.
( ) Mount one side of both CLAMPS to the REAR CHASSIS using one No. 6-32
x
3/4" screw.
Turn the screw just enough to catch the threads. The clamps should be loose enough to move up
and down and rotate.
3. ( ) Place the SCREEN (the printed surface facing in) into the PLASTIC BEZEL.
4. ( ) Remove the backing from the four pieces of FELT. Place them on the inside surface of the
four protrusions on the PLASTIC BEZEL.
5. ( ) Insert the CRT TUBE, V9, into the rear of the PLASTIC BEZEL. Rest the base of the tube
on the bottom clamp.
6.
( ) Swing the TOP CLAMP over the base of the tube. Line up the holes and secure the tube by
using another No.
6
-
3
2
x
3/4" screw.
CAUTION
Make certain that the CRT tube is into the PLASTIC
BEZEL as far as it can go and the clamp is over the
base.
Turn back on the screws a half a turn enough to allow the tube to rotate in the assembly for
further alignment.
22
