RC Systems 10-0517, Operation Manual

Page: 48 / 51

UM-1096
Revision A 43
Appendix 8 Channel States
Priority Channel State Screen Color Description
1 MFG Green State when performing manufacturers checkout process
2 Diagnostic White Not visible since it is a menu item
3 Inhibit Green Used in PGA/Balance/Voltage screens
4 Corrupted Red Sensor Memory is corrupted
5 Sensor Error Red Sensor is found/valid, but failed to read information from the sensor
6 Type Error Red Sensor mismatch, and user failed to accept the sensor
7 No Sensor Red Sensor is not found
8 Cal Needed Red A calibration of the sensor is required
9 Comm Error Red Indicates timeout or invalid reply from Modbus or wireless device
10 I/O Error Red Indicates a failure to communicate between I/O board electronics
11 Config Error Red Indicates interface for Modbus/wireless is configured for something else
12 Warmup Green Indicates the detector is in the user defined warmup time period
13 Overrange Current Alarm Color Indicates the sensor is reading over the maximum allowable range
14 Cal Zero Pink Indicates calibration mode
15 Cal Span Pink Indicates calibration mode
16 Cal Purge Pink Indicates the detector is in the user defined cal purge time period
17 Fault Red Indicates a fault condition exists
18 Alarm 3 User Programmed Indicates the Alarm 3 condition exists
19 Alarm 2 User Programmed Indicates the Alarm 2 condition exists
20 Alarm 1 Yellow Indicates the Alarm 1 condition exists