UVB-100 Operating Procedure : Operating the UVB-100
© Copyright 2010 RBD Instruments, Inc.
To ensure that changes cannot be made to the setting you define, press the Lock button. Changes will
not be possible until the Lock button is pressed again to turn the lock off. (There is a Lock Indicator
light in the upper left area of the Timer panel.)
5.
Following all safety procedures, flip the Start/Stop switch up; it temporarily stays in the Start
position to start the timer. The amber Timer On indicator and the UV Lamp On indicator will be
illuminated.
6. Verify that the UVB-100 Emitter in the vacuum chamber is glowing. Full intensity is reached in 2 to
3 minutes.
7.
To temporarily stop the timer and turn off the UVB-100 Emitter, flip the Start/Stop Switch to the
Stop position. The elapsed time display will reset to 0. The amber Timer On indicator and the
UV Lamp On indicator should not be illuminated.
8.
To resume the timer function, flip the Start/Stop Switch up to the Start position. The amber Timer On
indicator and the UV Lamp On indicator will be illuminated again.
9. After the set time has elapsed, the Timer will turn off the UV Emitter. The amber Timer On indicator
and the UV Lamp On indicator should not be illuminated.
Figure 4. Timer Front Panel
10. Turn the key counterclockwise to its Off position. The Power On indicator and amber Timer
indicator will turn off.
Notes:
• If you need to change the set time after timing has started, flip the Start/Stop switch to the Stop
position and adjust set time as desired. Flip the Start/Stop switch to the Start position to re-start
the timer. If you are unable to change the set time, confirm that the Lock button hasn’t been
pushed.
•
The Timer retains all its settings when the power to the UVB-100 Control is Off.
Page 10
