INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia
1300 788 778 www.rba.com.au |
New Zealand
0800 722 111 www.rbagroup.co.nz
2 of 5
• 1x Straight rail [for RBA490X-straight-series]
• 1x Ambulant rail [for RBA490X-450]
• 2x Flange cover
• 2x Wall plate
Attention
You are responsible for the safe operation of this unit.
For optimum installation use at least 4 suitable screws for each wall
plate. Screws should be selected to suit the wall type. Grab rails are no stronger than the anchors or walls to which they are
attached, and therefore must be firmly secured in order to support the loads for which they are intended.
Exceeding the maximum load values may cause permanent product damage. If this happens, cease use until checked by
a specialised maintenance person. Improper use, such as for gymnastic exercises or as a step, may cause accidents with
serious consequences. Reliable operation and product safety depend on the way the products are installed and used.
Ensure installation is performed by qualified personnel. Incorrect installation can seriously compromise product functionality.
Steri+Shield
TM
seals
ARE NOT
intended to be a substitute for, or a replacement of, waterproofing membranes or substrates.
Maintenance and Cleaning Instructions
Do not use detergents containing bleach, acids, alkalis, chlorine or abrasive products. Do not use abrasive objects [e.g.
scouring pads]. Do not use chemicals that can damage plastic. Clean the surface with water and a neutral detergent; rinse
carefully and dry with a clean cloth. If alternative cleaning methods and/or chemicals are used, warranty may become void.
Components Supplied for RBA490X-901 & RBA490X-911
• Extended Driver Bit
• Screw Driver
• Spirit Level
Components Supplied for RBA490X-Straight-Series & RBA490X-450
Tools Required
• 1x Long straight rail [open-ended]
• 1x Short straight rail [open-ended]
• 1x LH connector rail [for RBA490X-901]
• 1x RH connector rail [for RBA490X-911]
• 2x Dress rings
• 2x Large ID flange cover
• 1x Handset, Slider & Hose Kit (RBA490X-721 only)
• 1x Handset, Slider, Hose & Mixer Kit (RBA490X-722 only)
• 1x Open-ended straight rail
• 1x Double-ended straight rail
• 1x Rail connector
• 3x Bolt
• 1x Small ID flange cover
• 3x Wall plate
• 3x Bolts
• 12x Screws
• 12x Wall plugs
• 1x Steri+Shield
TM
Accessible Seal Kit
• 3x Flange cover
• 3x Wall plate
• 12x Screws
• 12x Wall plugs
• 2x Steri+Shield
TM
Straight/Ambulant/Shower Kits
Components Supplied for RBA4901-Shower-Rails
• 2x Bolts
• 8x Screws
• 8x Wall plugs
• 1x Steri+Shield
TM
Straight/
Ambulant/Shower Kit
