6
Safety Rules for Cut-Off Saw
1. Read
and
understand
the operation manual before operation.
2. Keep hands away from the cutting area.
3. Before making any adjustments disconnect all power sources including
electrical and pneumatic.
4. Minimum air pressure is 50 psi, DO NOT operate saw if minimum air
pressure is not available. Normal working pressure is 80psi.
5. At the start of each work session turn on saw and trigger the two hand trip
with no work piece present, cycle the saw and check for normal operation
of top clamp and blade advance cylinders. Turn off saw and as the motor
slows and comes to a stop check for correct rotation direction compared to
arrow indicator.
6. Do not cut warped wood; work piece should lay flat on table without
rocking.
7. Use infeed and outfeed supports when cutting long work pieces.
8. Set top clamp stop pin to limit opening height to only what is required to
process the work piece.
9. Never place hands under top clamp; remove cut piece by pulling it out from
under open top clamp. Short trim scraps should only be removed by
pushing them out with a scrap piece.
10. Always use push roller handles to position and guide work piece against
fence. Do not use hands to support work piece.
Summary of Contents for Cyclone
Page 2: ...1 ...
