19
Adjustments to square cut
Adjusting fence square to blade to give a square cut on workpiece requires a
measuring device, (tape measure, calipers, or spacer block), 3/16 allen
wrench, and a square to check work piece. The reference block along the
back edge of the saw table has been squared to the saw blade at the factory.
This reference block will be the starting point for squaring the fence in any of
the optional mounting positions. Determine mounting position for fence, move
fence and mounting screws to desired position do not tighten screws at this
time. Using the tape measure determine distance from reference block to
back edge of fence, set the fence so that the back edge is parallel to the
reference block, same distance from reference block at both ends of
reference block. While maintaining the desired measurement tighten the
fence mounting screws, check the distance after tightening, adjust if
necessary.
Cut a part and use square to check. If finer adjustment of square is required
leave mounting screw closest to blade tight and just break loose outer two
mounting screws. Use a soft face mallet to tap fence in direction as indicated
by work piece and square, retighten screws and check for square. A spacer
block made to fit between fence and reference block will speed squaring
process if needed in future.
The operator must remove from and
lock out all power to saw before
servicing or adjusting.
DANGER
Summary of Contents for Cyclone
Page 2: ...1 ...
