66
1.2 Overview
1 The Razor BAT Wing
Once your Razor Harness and T Weight System have been set up then you can
attach the BAT Wing to the Harness.
The BAT Wing should be worn with the Primary Wing on the outside and the
Backup Wing on the inside.
This makes finding both the Primary and Backup wing dump valves easier and
allows both to be vented more effectively and the Backup
wing is very well protected.
The design of the BAT wing places the position of the
dump valve and the inflator elbow in a well protected
low profile position between the Side Mount tanks
and the diver’s body.
In addition the outside material of the wing is not placed
between a hard object such as the dump valve and
the ceiling of a cave, or a sharp object in a wreck
for example where it may be more prone to
damage.
In the very unlikely event that the dump
valve or inflator elbow or large diam-
eter inflation hose should be dam-
aged these components are easily and
cheaply replaced which is not the case
if the wing material is damaged.
The BAT Wing is supplied with a 19”
long large diameter inflation hose
and a short LPI hose.
This configuration should fit just
about everyone but shorter large
diameter inflation hoses of 16” or
13” and LPI hoses of 8” or 4” can be
purchased separately in order to
customize hose lengths if required.
