Appendix
54
Rev. B 09/2011
Pi20
9.3
Configuring of I/O Modules
9.3.1
Overview
It is recommended to use an Ethernet switch to connect the Ethernet port of the I/O Module to the
computer, as shown in the
on page 9.
9.3.2
Installing the Configuration Software
For the module IP address setting, you will need to use the ADAM.NET Utility software
8
found on the
ADAM support CD.
Figure 24: Installing the ADAM.NET Utility Software
Before installing ADAM.NET Utility, you need to install .NET Framework 1.1 or later!
9.3.3
IP Address Setting
After you have confirmed the hardware wiring between host PC and your ADAM-6000 module, you
can find that module in ADAM.NET Utility software by following the steps below:
1.
Launch ADAM.NET Utility software.
2.
Select the <ADAM5000TCP_6000> item
①
on the module tree display area.
3.
Right click the <ADAM5000TCP_6000> item and activate <Search>. ADAM.NET Utility will
then search all ADAM-6000 modules on the Ethernet network. You will find it showing on the
<Others> item
②
and under the status display area
③
.
8
Copyright © Advantech Co., Ltd. All Rights Reserved