Installation
Pi20
Rev. B 09/2011
21
5.7
Cable Connections
Before connecting and disconnecting any connector, make sure that the power switch is
off!
To maintain EMI compliance to CE standards the attached Ferrite cores need to be
placed on the Ethernet and power supply cables! You have to assemble the Ferrite cores
after cables have been pulled through pipes, holes, etc. Please note, the Ferrite cores
withstand temperatures up to 105°C (221°F).
Figure 9: Ferrite Core Shells and Safety Key
5.7.1
Connecting the Ethernet Cable
The straight Ethernet cable comes with an IP67 connector assembled to one end of the camera, and an
IP20 connector at the other end. The standard cable is about 5 mm (0.2 in) in outer diameter and 7.5 m
(25 ft) long. Other cable lengths are available as an accessory. The cable withstands ambient
temperatures up to 180°C (356°F).
To connect the Ethernet cable follows the steps below:
1.
Remove the cap.
2.
Connect the Ethernet cable plug straight into the Ethernet terminal on the body by closing the
connector latches!
5.7.2
Connecting the Power
The power supply cable comes with a connector assembled to one end of the camera, and a pig tail on
the other end. The standard cable is about 5 mm (0.2 in) in outer diameter and is 7.5 m (25 ft) long. The
cable withstands ambient temperatures up to 180°C (356°F).
To connect the power, follow the steps below:
1.
Connect the power connector to the camera.
2.
Tighten the nut on the connector.
Use the safety key to open the
Ferrite core shells