Raypak P-R185B To P-R405B, C-R185B To, Installation And Operating Instructions Manual

Page: 14 / 52

14
SECURING THE TOP PANEL COVER
INDOOR KIT ONLY
7. Reinstall the louvered top.
8. Mount the draft hood onto the adapter plate lip inside
the heater. See Fig. 6.
9. Proceed to installing the clips, step 14.
SECURING THE TOP PANEL COVER
OUTDOOR KIT ONLY
10. After removing the drafthood from the box, slide the
top panel cover over the draft hood. See Fig. 1.
11. Holding both pieces together, mount the draft hood
on the adapter plate lip inside the heater. See Fig. 6.
12. Take the two pieces of tape and attach to each side
of the drafthood leaving 6" hanging down.
13. Slide the top panel cover up and attach the tape to the
underneath side. This is to temporarily keep the top
panel cover out of the way while you are attaching the
clips as shown in the next steps. See Fig. 7.
INSTALLING THE CLIPS
INDOOR & OUTDOOR KITS
14. Notice that there are three pilot holes above the base
of the drafthood as shown in Fig.8. These are the
locations where the three clips are to be attached.
15. Insert the long edge of one clip between the top panel
cover and the drafthood, see Fig. 9.
16. With a twisting motion, rotate the clip up, see Fig. 10.
17. Pull up on clip, see Fig. 11.
18. Hold the clip up and align the clip hole to the pilot
hole, see Fig. 12.
19. Insert screw into hole and secure using a 5/16" nut
driver.
20. Repeat steps 6-10 using remaining two clips.
21. This completes the indoor drafthood installation. If
installing an outdoor drafthood, proceed to step 13.