PART TWO
INSTALLATION AND SERVICE INSTRUCTIONS
SECTION 1 - RECEIVING EQUIPMENT
INSTALLERS
- The manufacturer recommends that this manual be reviewed thoroughly before installing the
pool/spa heater. If there are any questions that this manual does not answer, please contact the factory or your
local representative.
On receipt of your equipment it is suggested that you visually check for external damage to the carton. If the
carton is damaged, a note should be made on the Bill of Lading when signing for the equipment. Remove the
heater from the carton. If it is damaged, report the damage to the carrier immediately. Save the carton.
These items are shipped inside a box in the carton with the heater:
1.
"Pagoda" top
2.
In/Out flanges (2)
3.
2" CPVC female tailpiece, ring nut and o-ring
4.
2" flange gaskets (2)
5.
Flange bolts (4)
6.
Pressure relief valve
7.
2" CPVC adapter
8.
Plastic pipe finish flange for gas line.
9.
Bonding lug with mounting screw.
10. 2” CPVC manifold adapter
11. Prewired 1” flow switch with outdoor cover
12. Temperature & pressure gauge.
Be sure that you receive the number of packages indicated on the Bill of Lading.
When ordering parts, you must specify the model and serial numbers of the heater. See below for location of
serial number. When ordering under warranty conditions, you must also specify date of installation.
The Model & Serial No.
can also be found inside
the bezel above the display
Model & Serial No.
located on
Rating Plate
Alternate
Rating Plate
location
9
