28
Programming
Reprogramming Light or Additional Light
Your garage door opener remote light has already been programmed at the factory to
operate with your opener. Any additional or replacement remote lights will need to be
programmed.
1. Press the LEARN button on the light until the LED comes ON.
2. Activate the garage door opener using the hand-held remote, door control, or keyless
entry.
3. The code has been programmed when the remote light comes on.
Additional Programming for the Keyless Entry (Not
Provided)
TO CHANGE AN EXISTING, KNOWN PIN
If the existing PIN is known, it may be changed by one person without using a ladder.
1. Press the four buttons for the present PIN, then press and hold the # button. Release
the # button.
2. Press the new 4-digit PIN you have chosen, then press ENTER.
Test by pressing the new PIN, then press ENTER. The door should move.
TO SET A TEMPORARY PIN
You may authorize access by visitors or service people with a temporary 4-digit PIN. After
a programmed number of hours or number of accesses, this temporary PIN expires and
will no longer open the door. It can be used to close the door even after it has expired. To
set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the last temporary PIN), then
press and hold the
✽
button. Release the button.
2. Press the temporary 4-digit PIN you have chosen, then press ENTER.
3. To set the number of hours this temporary PIN will work, press the number of hours
(up to 255), then press
✽
.
OR
3. To set the number of times this temporary PIN will open door, press the number of
times (up to 255), then press #.
Test by pressing the four buttons for the temporary PIN, then press ENTER. The door
should move. If the temporary PIN was set to a certain number of openings, remember
that the test has used up one opening. To clear the temporary password, repeat steps 1-3,
setting the number of hours or times to 0 in step 3.
ONE BUTTON CLOSE:
The garage door opener can be closed by pressing only the ENTER button if the one
button close feature has been activated. This feature has been activated at the factory.
To activate or deactivate this feature press and hold buttons 1 and 9 for 10 seconds. The
keypad will blink twice when the one button close is active. The keypad will blink four
times when one button close is deactivated.
