Installation
13
Install the LED Driver
Tip:
Before You Begin
•
See the
for example systems.
•
Install the related products including the Lyda lamp head and optional DMX
Adapter prior to installing the LED driver.
CAUTION:
Risk of personal injury and/or product damage. Handle the LED
driver carefully. Do not lift, suspend, or move the driver using the input or
output wires.
1.
Rotate
clockwise
to disconnect
Rotate
counter-
clockwise
to connect
Using M4 (#8) hardware, secure the LED driver to a suitable structure
using the built-in mounting flange. The installation location must be
within 3 m (10 ft) of the desired Lyda lamp head installation location.
2. Connect the lamp cable from the LED driver to the installed Lyda
lamp head. The connection is secured by rotating the locking ring
counterclockwise until finger tight.
3. Connect the control cable (optional use for 1-10 V dimming control).
•
If using the DMX Adapter, connect the control cable from the DMX Adapter to the input
connector on the LED driver.
•
If using a third-party 1-10 V controller, connect the 1-10 V Dimming Cable (L-DCBE) to the
connector provided on the LED driver and terminate the bare end wires to the third-party
dimming controller.
Purpose Wire Color
Notes
Dim +
violet
1 to 10 V
Dim -
gray
0 V Return
Unused
black/white
This wire is not used for third-party 1-10 V controller purposes
4. Connect the LED driver to the power source. If using a connectorized power input cable,
simply plug the unit into the distributed power input receptacle. If using a bare end power
input cable, terminate the wiring according to the cable type and local codes.
Model
Type
Color
Power Cable,
US Color Code
ground/earth
green
line
black
neutral
white
Power Cable,
IEC Color
Code
protective
earth
green/yellow
line
brown
neutral
blue
