12
Lamp Head and LED Driver Installation and User Manual
2. Each end cap is provided with three mounting holes (10 mm [3/8 in] Ø) for directional
suspension. Attach mounting hardware (not provided) to the suspension points (each end
cap must be supported). You can interlock (link) end caps together, sharing a suspension
point between two linked end caps, creating linear arrays of the lamp heads.
CAUTION:
For effective convection cooling and to prevent overheating, do
not install the lamp head vertically on its end.
Y
X
3. If the LED driver has been previously installed, connect the lamp cable from the driver to the
Lyda lamp head. The connection is secured by rotating the locking ring counterclockwise
until finger tight. If the LED driver is not yet installed, see
Install the LED Driver on the facing
for instructions.
Rotate
clockwise
to disconnect
Rotate
counter-
clockwise
to connect
CAUTION:
Do not make or break connection under load.
ATTENTION :
Ne pas brancher ou débrancher sous charge.