Before You Begin Installation
11
Before You Begin Installation
•
Prior to installation, review all safety information. See
.
•
Review the
information.
•
When linking the lamp heads together lengthwise, always secure them at both ends.
•
Ensure the installation location and installation hardware can support four times the weight
of the lamp head, cables, and any installed accessories. See
.
Installation
WARNING:
Risk of electric shock! This device utilizes high voltage and
should only be installed by a qualified installer or electrician. Follow all
local codes for installation. Before terminating the AC power wiring
verify that the main breaker is in the off position and follow the proper
lockout/tag out procedures per NFPA Standard 70E or applicable local
regulations.
AVERTISSEMENT :
Risque de décharge électrique! Cette appareil
utilise une haute tension et ne doit être installé que par un installateur
qualifié ou un électricien. Suivez tous les codes locaux pour
l'installation. Avant de raccorder le câblage du courant alternatif,
vérifiez que le disjoncteur principal est en position d'arrêt et suivez les
procédures de Consignation/Déconsignation prescrites par la norme
NFPA 70E ou aux réglementations locales applicables.
Note:
For North American installation, lamp head and LED Driver power cables shall
be installed so that they are visible over the entire length (as opposed to the building
infrastructure cables or conduit). Concealing of the cables within walls, floors ceilings
or above suspended or dropped ceilings is not allowed. Cables shall be installed so
they are not subject to strain or damage.
Install the Lyda Lamp Head
The Lyda lamp head can be mounted by suspension or by a mounting bracket in a horizontal (X)
or vertical (Y) orientation using the end caps as the attachment points (mounting hardware not
provided).
Each end of the lamp head must be secured. Lamp heads may be linked together at the ends,
end cap to end cap, and may share the same suspension chain (or suitable alternative) at that
point.
The lamp head can be installed projecting downward, horizontally sideways for interlighting
applications, or built-in to a shelving system with suitable clearance. See
Note:
The lamp head must be installed within 3 m (10 ft) of the LED driver.
1. For installation convenience, install factory accessories, such as a lens accessory, prior to
suspending or attaching the lamp head to the installation location.