Raymarine ST70 Instrument, User'S Reference Manual

Page: 13 / 48

Chapter 2: Commissioning Procedures 7
Chapter 2: Commissioning Procedures
Before an ST70 instrument is used for the first time, it must be commissioned in
accordance with the instructions in this chapter, to carry out:
•
Dockside setup
followed by
• Seatrial calibration .
2.1 Dockside setup
Notes: (1)
If your ST70 instrument is connected to an existing SeaTalk
ng
system that has
already been successfully commissioned, you do not need to commission the
new instrument.
(2)
Values set during Dockside setup can be changed subsequently, if necessary.
Use these Dockside setup instructions when an ST70 instrument is first started after
installation to:
•
Switch on the instrument.
• Carry out the initial setup procedures, to:
•
Select language.
• Set vessel type.
• Set date and time format (only if GPS is fitted).
• Set correct local time (only if GPS is fitted).
• Set required data units.
• Set the correct depth offset.
• Set the correct magnetic variation.
• Set the required method for calculating ground wind.
• Set the water temperature.
• Set the instrument response.
Switch on
Hold down the power button for 1 second to power
up the instrument. When the instrument is first
switched on after installation, a select
Language
menu is displayed.
WARNING: Product installation & operation
Each ST70 instrument must be prepared for use in accordance with the
Commissioning Procedures, before it is used for operational purposes,
unless it is part of a SeaTalk
ng
system in which at least one other ST70
instrument is already set up and working, it. Failure to comply with this
could result in death, personal injury, damage to your boat and/or poor
product performance.
D9342-1
Press ENTER to select
Language
English (UK)
81284_1.book Page 7 Friday, May 4, 2007 7:29 AM