Raymarine ST600R, Owner'S Handbook Manual

Page: 74 / 93

63
Chapter 7: Post Installation Procedures
Wind Transducer Interface
If the course computer is connected to a wind instrument via an
NMEA port or SeaTalk, then the link between the two instruments
should be checked as follows:
Press STANDBY and AUTO together.
The ST600R should display the Vane mode screen, with the locked
wind angle and locked heading as shown.
DXXXX-1
WIND
145P
auto stdby
Alternatively, if the wind data is not received , the ST600R will
display a NO DATA error message.
EMC Conformance
The design and manufacture of
Raymarine
equipment and
accessories conforms to the appropriate Electromagnetic
Compatibility (EMC) standards, but good installation is required to
ensure that performance is not compromised. Although every effort
has been taken to ensure that they will perform under all conditions,
it is important to understand what factors could affect the operation
of the product.
Always check the installation before going to sea to make sure that it
is not affected by radio transmissions, engine starting etc..
In some installations, it may not be possible to prevent the
equipment from being affected by external influences. In general
this will not damage the equipment but can lead to it resetting, or
momentarily may result in faulty operation.