28
Circuit breaker and fuse information
Select the appropriate circuit breaker or fuse for your system using the table below as
a guide.
To connect the power and drive unit
•
Fit the power cable to the distribution panel.(We recommend using a dedicated
circuit breaker for the power cable).
•
Route the power cable to the SPX SmartPilot and fit it to the POWER INPUTS ter-
minal.
•
Connect the drive cables to the DRIVE MOTOR OUTPUTS terminal.
•
Connect the drive to the DRIVE CLUTCH OUTPUTS.
Motor phasing is determined during commissioning: refer to separate commissioning
guide for further information.
Type 3 drive 12 V
(X30)
up to 5m (16ft)
8 AWG
10 mm
2
Type 3 drive 24 V
(X30)
up to 5m (16ft)
10 AWG
6 mm
2
up to 7m (23ft)
8 AWG
10 mm
2
Drive unit
Fuse
Thermal over-current circuit
breaker
Rotary drive
Linear drive
Hydraulic pump
Hydraulic linear
Type 1, 12 V
25 A
20 A
Type 1,24 V
25 A
20 A
Type 2, 12 V
40 A
30 A
Type 2, 24 V
30 A
30 A
Type 3,
12V and 24V
40 A
30 A
I/O
15 A
10 A
CR pump solenoids
10 A
10 A
Drive type
Cable length
Cable gauge
Copper area
87072-2.book Page 28 Thursday, November 22, 2007 8:43 AM
