Raymarine SmartPilot ST7002, Operating Manual

Page: 13 / 52

Chapter 1: SmartPilot Operation 3
When the power supply is switched off, the SmartPilot controller buttons have no
effect.
Notes: (1)
Each time power to the SmartPilot controller is switched on, the control-
ler is initially in the on condition. You do not need to use the disp
button to switch the controller on.
(2)
When the SmartPilot controller is on, the operation of the disp button
will perform other operating functions, as described below.
Start-up mode
The SmartPilot always powers up in Standby mode with the display showing the
boat’s current compass heading.
Note:
You can press
standby
at any time to return to manual steering.
Keypad functions
The SmartPilot is controlled using simple push-button operations, all of which are
confirmed with a short beep. In addition to the main single-button functions,
there are several dual-button operations.
D5448-3
track
Press for Track mode from Auto mode
(if a navigator is connected)
Press to accept waypoint advance
Press for 1 second to skip waypoint
auto
Press for Auto mode
standby
Press for Standby mode
Press for 2 seconds
to enter Calibration mode
course change keys
-1
= Port 1˚
-10 = Port 10˚
+1 = Starboard 1˚
+10 = Starboard 10˚
-1 plus -10
Press together for
AutoTack to port
+1 plus +10
Press together for
AutoTack to starboard
-1 plus +1
Press together for
response level
-1 plus +1
Press for 1 second
for rudder gain
standby plus auto
Press for Wind Vane mode
(if a wind vane is connected)
resp
Press to display response level
Press for 1 second for rudder gain
Press to select Wind Vane mode
(if a wind vane is connected)
res'm
Press to resume previous course
&
Press to scroll through calibration parameters.
Press to adjust response and gain
disp
mode
mode
Press to display data pages
When powered
down, press for 1
second to power up
Press for 9 seconds
(in Standby mode)
for power down
Press for 1 second for lamp adjust
Press for 3 seconds
for contrast adjust