Raymarine SmartPilot SPX-10, Installation Instructions Manual

Page: 30 / 50

You can connect an autopilot controller at each helm position.
Note: Only autopilot controllers compatible with SeaTalk ng can
be connected to the backbone.
SeaTalk ng connection to course computer
The course computer connects to the SeaTalk
ng
backbone using
the spur cable supplied.
D10458-2
Rayma rine
P OWER
P OWER
P
O
W
E
R
12V
OFF ON
24V
FLUXGATE RUDDER
CLUTCH
FAULT
S LEEP
FAULT
2
1
3
4
1. SeaTalk ng power switch
2. Course computer connector panel
3. SPX to SeaTalk ng spur cable
4. SeaTalk ng backbone
Note: The connection at the backbone may be into a T-piece
or 5 way connector (not shown)
SeaTalk ng power switch
The course computer can provide power to the SeaTalk ng backbone.
This will provide power to certain equipment connected to the
backbone (e.g. ST70 pilot controller and instruments).
Set the SeaTalk ng power switch on the connector panel to the
appropriate position:
• ON — The course computer will supply power to the SeaTalk ng
backbone. Ensure that there are no other power feeds connected
into the backbone.
• OFF — The course computer will not supply power the SeaTalk ng
backbone. Ensure that there is a separate power feed to the
SeaTalk
ng backbone.
Important: Use correct fuse. The fuse supplying the SeaTalk ng
system MUST be rated as per the value shown on the connector
panel.
30 SPX SmartPilot installation instructions