Raymarine RMK-9, Installation And Operation Instructoins

Page: 5 / 12

6. Documentation pack.
7. Right angled power cable 2 m (6.6 ft.).
8. RayNet network cable 2 m (6.6 ft.).
Location and mounting
Keypad dimensions
A
B
C
D
E
F
D12726-1
A 132.9 mm (5.23 in)
B 119 mm (4.7 in)
C 18.7 mm (0.74 in)
D 8.5 mm (0.33 in)
E 37 mm (1.5 in)
F 90 mm (3.5 in.)
Flush mounting the keypad
For flush mounting you must rebate the mounting
surface to accommodate keypad.
D12708-1
1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Before modifying the mounting surface, refer to the
dimensions supplied in this document to ensure
there is enough space for the unit and all cables.
3. Fix the supplied mounting template to the selected
location, using masking or self-adhesive tape.
4. Drill 4 holes as indicated on the mounting template
to accept the fixings.
5. Using a suitable hole saw (the size and position
is indicated on the template), make a hole in each
corner of the cut-out area.
6. Using a suitable saw, cut along the inside edge of the
rear casing cut-out line indicated on the template.
7. Using a router follow the rebate cut-out line on the
template to cut out a rebate with a depth of 8.5 mm
(0.33 in), to accept the unit.
8. Ensure that the unit fits into the removed area and
then remove rough edges.
9. Place the supplied gasket onto the rear of the
keypad, ensuring the mounting holes are aligned.
10. Connect relevant cables.
11. Place the keypad into the rebate and secure using
the fixings provided.
Note: The appropriate tightening torque and drill bit
size to use depends on the thickness of the mounting
surface and the type of material it is made from.
Note: The supplied gasket provides a seal between
the unit and a suitably flat and stiff mounting surface
or binnacle. The gasket should be used in all
installations. It may also be necessary to use a
marine-grade sealant if the mounting surface or
binnacle is not entirely flat and stiff or has a rough
surface finish.
Surface mounting the keypad
D12722-1
1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Before modifying the mounting surface, refer to the
dimensions supplied in this document to ensure
there is enough space for the unit and cables.
3. Fix the supplied mounting template to the selected
location, using masking or self-adhesive tape.
4. Drill 4 holes as indicated on the mounting template
to accept the fixings.
5. Using a suitable hole saw, make a hole in each
corner of the cut-out area.
6. Using a suitable saw, cut along the inside edge of the
rear casing cut-out line indicated on the template.
7. Ensure that the unit fits into the removed area and
then remove rough edges.
5