12
1. Select
Transducer
from the Fishfinder app’s
Settings
menu:
Menu
> Settings > Transducer
2. If your installation required you to install an all-in-one transducer
backwards (e.g.: this may occur when connecting the transducer to
a trolling motor), then select
Backwards
from the
HV transducer
alignment
option. This ensures that the port and starboard
channels appear correctly orientated onscreen, otherwise keep
the default setting:
Forwards
.
3. Select where you want your depth measurements taken from:
i.
Below transducer (default) — No offset required
ii. Below keel — Enter the distance between the transducer face
and the bottom of the keel.
iii. Below waterline —Enter the distance between the bottom of
your keel and the waterline.
4. You can configure temperature settings as follows:
i.
Enable or disable temperature readings as required.
ii. If enabled, check the temperature reading against the actual
water temperature.
iii. If the current reading requires adjustment, select
Calibrate
temp
and enter the difference between your 2 readings.
Identifying engines
Engine data can be shown on your display, if your engines are
transmitting the relevant supported data on the same network as your
display. If your system has mislabelled your engines then you can
correct this using the Engine identification wizard.
The Engine identification wizard can be accessed from the Boat details
menu:
Homescreen > Settings > Boat details > Identify engines
.