Raymarine CYCLONE, Installation Instructions Manual

Page: 35 / 92

1. Wedge or washers
6.6 Multiple Radar scanners — location requirements
Important location considerations when installing multiple radar scanners on the same vessel.
• Scanners should be mounted above each other, vertically separated by at least 0.5 m (1.6 ft). This
applies to all installation locations on the vessel.
• Multiple scanners should be mounted in a way that minimizes interference between the vertical
beamwidths of the 2 scanners.
• In all cases, you should aim to achieve as much physical separation as possible, to minimize
any potential interference.
6.7 VCM100 location requirements
When selecting a mounting location it is important to consider a number of factors.
Ventilation
• Ensure that equipment is mounted in a compartment of suitable size.
• Ensure that ventilation holes are not obstructed. Allow adequate separation of equipment.
Mounting surface
Ensure equipment is adequately supported on a secure surface. Do not mount units or cut holes in
places which may damage the structure of the vessel.
Cables
Ensure the unit is mounted in a location which allows proper routing and connection of cables:
• Minimum bend radius of 100 mm (3.94 in) unless otherwise stated.
• Use cable supports to prevent stress on connectors.
• The maximum length of cable between the battery and the VCM100 should not normally exceed
19.6 ft. (6 M). All power cable lengths should be kept as short as possible.
Water ingress
The VCM100 is splashproof, and suitable for mounting below decks only.
Electrical interference
Select a location that is far enough away from devices that may cause interference, such as motors,
generators and radio transmitters/receivers.
Magnetic compass
Mount the VCM100 at least 3 ft (1 m) away from a magnetic compass.
Location requirements
35