Raymarine CP450C, Installation Instructions Manual

Page: 23 / 56

Transducer pair connections
Transducer Pair
Frequencies
Cable Channel A Cable Channel B
Low & High Low frequency
transducer High frequency
transducer
Low & Medium Low frequency
transducer Medium frequency
transducer
Medium & High Medium frequency
transducer High frequency
transducer
Note: When fitting transducer pairs ensure that channel A and
channel B of the transducer cable are connected to the relevant
transducer as shown in the table above.
Traditional transducer connection
1
3
D 12232-1
2
Item Description
1 CP450C
2 Legacy Adaptor cable
3 Traditional transducer
Warning: Transducer cables
Do not remove the transducer cable whilst the product
is powered on, doing so can cause sparks. If the
transducer cable is accidently removed whilst the
product is powered on, switch the product’s power off,
replace the cable and then switch the power back on.
Caution: Do not cut transducer cables
• Cutting the transducer cable severely reduces sonar
performance. If the cable is cut, it must be replaced,
it cannot be repaired.
• Cutting the transducer cable will void the warranty
and invalidate the European CE mark.
Transducer adaptor cables
Below is a list of transducer adaptor cables which may be required:
Description Part number
Transducer 3m extension cable A102148
Transducer 5m extension cable A102150
Legacy Transducer adapter cable A102147
Combined dual broadband transducer
cable A102146
Cables and connections 23