Raymarine Autohelm 100, Install Manual

Page: 58 / 109

Chapter 2: Installation 57
1. Push the mounting bracket behind the steering cable, sliding the
location pins either side (top and bottom) of the Volvo power steering
block.
2. The bracket clamp hinges onto the mounting bracket and is located
using the two allenhead key bolts. Tighten the two bolts evenly until
the bracket is securely located.
Bracket Large diameter
Valve block
Spool valve shoulder
Cable
clamp nut
D769-1
D129 Mounting bracket
D129 Mounting bracket
Location pin
Steering
cable
Bracket clamp
Volvo Penta
steering valve block
Steering cable Cable clamp nut
Valve shoulder to
remain out of bracket
3. Uncouple the engine tie bar from the outdrive tiller arm by bending
back the locking tabs and removing the cotter pin. This should be
replaced with the multi-engine adaptor pin. Make sure that it is
secured properly with a split pin (on single engine installations, fit the
single engine adaptor pin in the vacant middle hole in the tiller arm).