Installation
Chapter
5
MN049 / v1.0.0
3-Axis Subsystem AS-50 for Laser Beam Deflection
17
5.1
Mount subsystem
o
Carefully remove the protective cover over the beam input with a small screwdriver.
o
To install the subsystem, insert locating pins into the corresponding holes and attach the
subsystem to the prepared installation surface using screws.
Note:
The subsystem may only be installed using the pins and screws specified by
RAYLASE. Follow the installation drawing supplied.
5.2
Checking the beam coupling
5.2.1
Preparation
In order to be able to check the beam coupling, all components located in the beam path must
be removed. Take note of the following steps:
o
Remove the Focusing lens (1)
o
Open the cover (2)
o
Mark the position of linear translator (3)
o
Remove linear translator (3)
o
Protect the focusing lens and linear translator against dust.
Fig. 5
Preparing the
beam coupling
