Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-P500H
11
c)
Connect the power cable and control cable to the product when power
supply is OFF.
d)
Clamp the water pipes ontopipe connector, run the chiller to check if there
is any leakage in the water circulation.
e)
Check the output head and clean it before installation. This procedure must
be performed by Raycus personnel or person authorized by Raycus.
f)
Prevent the delivery cable from treading, pinching or excessive bending
during installation.
g)
Make sure the environment is clean, or the output head may be
CAUTION:
All the cables can only be connected when power
supply is off. Hot plug may damage the device.
CAUTION:
(1)
Ensure that there are no fiber bends in radius less than 30cm
when the product is installed. Avoid excessive twisting and
tight bends during the robotic arm movements.
(2)
Tight bends will damage the laser delivery system.
CAUTION:
(3)
Keep the protective cap properly, prevent it from
contamination; Or the aperture will be contaminated when
capped.
(4)
Make sure the aperture and the cavity of the processing head is
clean.
not be less than 20cm in the non-working state (such as transport and
storage). The minimum bending
radius
should not be less than 30cm
when the laser is work.
contaminated. It is prohibited to use fan during installation, which will
cause dust in the air.
h) The minimum bending
radius
of the transmission cable of the laser shall