9
Wuhan Raycus Fiber Laser Technologies CO., LTD.
P200MX Pulsed Fiber Laser User Instruction V1
3.1. Pre-inspection
1. Make sure the device appearance is in good condition and the output fiber is neither
excessively bended nor broken.
2. Make sure signal line of laser and marking system are properly connected.
3.2. Operation procedures
1. Starting procedures
Please make sure the control system is on before you turn on the fiber laser. Only after
at least 1 minute since the power turned on, the subsequent operations can be proceeded.
2. The frequency setting range is from 1 kHz to 4000 kHz(The actual frequency range of
each pulse width is showed in the Table 3).
3. The operation steps of laser marking after the marking machine is turned on checks
For the device initial testing, first turn the power down to 10% without turning on the
marking system after the device is successfully started. Then draw a quadrate,
marking continuously while slowly increasing the power from 10% to 100% at the
same time. Meanwhile, use a ceramic material to observe the laser and the laser
should become stronger, otherwise shut down the device and check. If operating
normally, the marking system can be used in common order afterwards.
3.3. Cautions
1. Marking frequency must be in the range of 1 kHz to 4000 kHz(The actual frequency
range of each pulse duration is showed in the Table 3).
2. Do not modify the frequency while marking.
3. Stop marking first before shutting down the device, then turn the power down to zero
and cut the power off.
