Rayco RG165T-R, Operator, Service, Maintenance Manual

Page: 27 / 72

RG165T-R Operator · Service · Maintenance
800.392.2686
27
Remote Function
1. Left Track Switch
Moves left track forward or reverse.
2. Right Track Switch
Moves right track forward or reverse.
3. Emergency Stop Switch
If the event arises this machine turns the machine off
completely
4. Blade Raise/Lower Switch
Raises or lowers the rear push blade.
Note: BE SURE
TO BE CLEAR OF THE BLADE WHEN IN OPERATION
5. Engine Speed Switch
Increases or decreases engine speed.
6. Remote Link Start Switch
Used during the linking procedure to establish remote
connection.
7. Display Screen
Notifies operator of machine functions .
8. Track Drive Speed Switch
Changes track drive speed from hi range to low
range.
9. Command Cut Swing Speed
Increases or decreases the swing speed of the cutter
boom. 0 being the slowest and 100 being the fastest.
10. Cutter Wheel Engagement Notification Light
Illuminates when the cutter wheel is engaged
11. Mandatory Action Switch
This switch has to be pressed to engage the cutter
wheel along with the cutter wheel engagement
switch.
12. Cutter Wheel Engagement Switch
Turns the cutter wheel on and off.
13. Cutter Boom Raise/Lower Switch
Raises and lowers the cutter wheel.
14. Cutter Boom Swing Switch
Swings the cutter boom left or right.
Operation
1
4
3
10
5
2
6
14
8
11
7
12
9
13
BEFORE ENGAGING THE CUTTER WHEEL, THE
OPERATOR MUST ENSURE THE AREA IS CLEAR
OF ANYONE OR ANYTHING THAT MAY BE HARMED
BY THE CUTTER WHEEL, OR FLYING DEBRIS.
TRACKS SHOULD BE EXPANDED TO 51” WIDTH
AT ALL TIMES UNLESS REQUIRED TO REDUCE
WIDTH TO GAIN ENTRY INTO A NARROW
SPACE. OPERATING MACHINE WITH TRACKS
LESS THAN 51” WIDE INCREASES THE RISK OF
MACHINE ROLLOVER. MACHINE SHOULD NOT BE
OPERATED WITH TRACKS LESS THAN 51” ON ANY
UNEVEN TERRAIN.