Turn the module selector to “PLAY”, LED (on the left side) shows the patch number; LCD
(on the right side) shows the patch name and master volume.
2. Set the unit to play mode
The LED display will show the information of current bank and patch number. Step on
[▼]/[▲]
footswitches to change patches (Hold one footswitch to switch patches quickly).
Pressing
[▲]
footswitch time and again (or holding
[▲]
footswitch for fast switching) cycles
through patches in the order A0 A9...J0 J9, 00 09...90 99, A0. Pressing or holding
[▼]
footswitch will switch patches in the opposite order.
Note:
Using pre-patch-select mode(
→
P32), you can jump directly to a patch that is far from the current patch.
3. Select a patch
When in play mode:
Turn the VALUE knob to adjust Master Volume.
Push the VALUE button to start/stop Drum playback.
14
~
~
~
~
Summary of Contents for MP-10
