11
Expression Pedal:
Adjusts volume or some effect parameters.
AUX IN Jack:
1/8” (3.5mm) stereo input audio jack, you can connect a CD player, MP3
Player or other devices for jamming, practicing, etc.
PHONES Jack:
1/8” (3.5mm) stereo output audio jack, for connecting headphones.
INPUT Jack:
1/4” mono audio jack, for connecting guitar.
USB Jack:
For connecting to a computer, then RAVO becomes a USB audio interface.
DC 9V Jack:
For power supply, use a 9-volt DC regulated by AC adapter, 500mA (plug
polarity is positive on the barrel and negative in the center).
Battery Holder:
For installing batteries (AAA x 4).
OUTPUT Jack:
1/4” stereo audio jack, for connecting guitar amplifier. You can use a mono
cable to output the signal to an amplifier, or use a Y cable to output the signal to two amplifiers.
Power switch:
For switching ON/OFF status.
NOTE: For using USB bus power, you should slide the switch to OFF position to get this unit powered.
8
6
7
10
9
11
13
12
14
Summary of Contents for MP-10
