Troubleshooting
● There is a lot of noise
• Check the shielded cables you are using for defects.
• Use only the HOTONE AC adapter.
• Try to adjust the GATE module settings again.
108
●
The unit will not turn ON
• Make sure the AC adapter is plugged in correctly.
• When using USB bus power, confirm the USB cable is connected correctly.
• When using batteries, make sure that they are still charged and the INPUT jack is plugged
in with cable.
●
No sound or very low volume
• Check the connections.
• Adjust the patch level.
• Adjust the master level.
• When adjusting the volume with an expression pedal, make sure that a suitable volume
setting has been set with the pedal.
• Confirm that unit is not in mute mode.
• The unit might have switched to standby to save power. In standby, audio input and
output are disabled.
Summary of Contents for MP-10
