Raveon RV-M8R, Technical Manual

Page: 13 / 51

Company Confidential 13
Raveon Technologies Corp.
ATEN
Data Encryption
–
0:disable. 1:AES128 GPS messages
2:AES128 Data and GPS messages. If not disabled, the
transmitted data is encrypted with the selected encryption
method using the
KEYPHRASE .
Range: 0, 1, 2 0 (off)
ATF
Display frequencies – Display all of the frequencies
programmed into all of the channel memories.
N/A
ATFT
Transmit Frequency – Program the transmit frequency for this
channel. Enter in Hz or in MHz. The frequency will
automatically be saved in non-volatile memory (flash) for this
current channel number.
Range:
See product data
sheet. For MURS products,
frequency cannot be
changed.
See product
data sheet.
ATFR
Receive Frequency – Program the receive frequency for this
channel. Enter in Hz or MHz. The frequency will automatically
be saved in non-volatile memory (flash) for this current channel
number.
Range:
See product data
sheet. For MURS products,
frequency cannot be
changed.
See product
data sheet.
ATFX
TX and RX Frequency – Program the receive and transmit
frequency for this channel. Enter in Hz or MHz. Same as
issuing an ATFR and an ATFT command. The frequency will
automatically be saved in non-volatile memory (flash) for this
current channel number.
Range:
See product data
sheet.
N/A
AT
HN
Channel Number Select current radio channel number. This
command does not store the channel number into EEPROM,
Range: 1 - 6
1
AT
HP
Channel Number
– Select current radio channel number. The
channel number is stored in EEPROM memory.
Range: 1 - 6
1
AT
IC
Read Current Draw Read the current draw in mA. Accuracy is
within 20% of actual current draw.
Range: 0-9999 N/A
AT
I0
Read/Set IO Mode Normal digital serial mode is 5. If plugged
into Tech Series enclosure (M21, M22), set this parameter to 8.
Cycle Power to radio after changing ATIO mode. Range: 0-8 5
AT
JF
Read/set the CTS threshold
– Set the serial buffer threshold
where the CTS line is negated. By default the ATJF level is at
80% of the internal buffer size. 1 - 2000
3800
AT
L
Enable/Disable the LEDs
– 1 = LEDs always off. This reduces
some power consumption. 0 = LED operate normally.
0 or 1 0
AT
MT
Modem Protocol Select
– The over-the-air communication
protocol. 0=Packetized mode, 2=streaming, 3=POCSAG paging
receiver. 8=Audio pass-through. Range: 0 or 3 0
AT
MA
Alternate Protocol
– If enabled, the alternate protocol is
selected with the Decode Mode input pin, 15.
Range: -1, 0, or 3 3
AT
NB
Parity
– Selects parity format. Settings 0-4 transfer 8-bits over
antenna port and generate the parity bit on the RF receiving side.
Range: 0
– 5
0 = none
1 = Odd
2 = Even
3 = Mark (1)
4 = Space (0)
0
AT
ND
Number of Data Bits
– Set/read the number of data bits.
Range: 5 - 8
8
AT
NS
Stop Bits
–
Selects the number of stop bits. Range: 1-2
1
AT
R1
Select CD pin output signal – CD may be RF carrier detect, or
modem data detect.
Range : 0 - 4
4 = Data Framing
3= Always negate CD
2 = Always assert CD
1 = Data CD
0 = RF CD
0