Raven SmarTrax John Deere 8X60 Series, Installation Manual

Page: 35 / 48

4
Manual No. 016-5034-020 Rev. B 31
Cab Component Installation
Install the Chassis Cable - SmarTrax-Only
Systems (If Applicable)
If the machine does not contain an existing chassis power system (such as AutoBoom, product control, et.), it
is necessary to install the chassis power cable to operate the SmarTrax system. If a CAN system already
exists on the machine, refer to
Connect SmarTrax to an Existing Chassis Cable (If Applicable) below to
connect power to the SmarTrax system.
Note:
The chassis cable is sold separately. Contact your local Raven dealer for ordering information.
1.
Locate the SmarTrax chassis cable (P/N 115-4001-085).
2.
Connect the TO SMARTRAX NODE connector from the chassis cable to the round 16-pin connector on the
node harness (P/N 115-4001-205).
3.
Connect the TO CONSOLE CABLE connector to the Raven console cable.
4.
Install a terminator (P/N 063-0172-369) on the CAN cable connector.
5.
Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
Note:
The REMOTE SWITCH connector is not used in the SmarTrax system. Ensure the cable is
secured away from moving parts and heat sources.
6.
Connect the ring terminals to the battery.
Note:
The positive connectors are fused.
Connect SmarTrax to an Existing Chassis
Cable (If Applicable)
Note:
The SmarTrax interface tee is sold separately. Contact your local Raven dealer for ordering
information.
1.
Locate and disconnect the connection between the Raven console cable and chassis cable on the
machine’s existing CAN system.
2.
Install the SmarTrax interface tee cable (P/N 115-4001-070 or 115-4001-071) between the chassis and
Raven console harness.
3.
Connect the SmarTrax node harness (P/N 115-4001-205) to the remaining SmarTrax interface tee.