Raven SmarTrax Case IH MX 210, Installation Manual

Page: 21 / 40

CHAPTER
5
Manual No. 016-0190-060 17
Chapter 5
Wiring and Electrical
Connections
Connecting the SmarTrax Hydraulic Valve
1.
Place a solenoid gasket (included in the packet with the console cable harness) on the solenoid installed in
port ‘1A’ on the SmarTrax hydraulic valve (P/N 334-0003-066).
2.
Locate the connector labeled ‘LEFT’ on the SmarTrax console cable harness (P/N 115-0171-775).
3.
Insert the connector labeled ‘LEFT’ to the solenoid installed in port ‘1A’ on the SmarTrax hydraulic valve.
4.
Tighten the bolt on the solenoid connector to secure the connection and to help prevent moisture
penetration.
5.
Repeat step 1 through step 4 to connect the ‘RIGHT’ connector to the solenoid on port ‘1B’.
FIGURE 1.
Solenoid Connections on the SmarTrax Valve
CAUTION
Ensure that the power cable is the last cable
connected.

Do not reverse the power leads. Doing so will
cause severe damage to the equipment.
Ensure the leads are connected to the correct
polarity.
Solenoid
Connections