Raven RCM-Sprayer Hawkeye 2, Calibration And Operation Manual

Page: 73 / 124

Troubleshooting: Diagnostic Trouble Code (DTC) List 63
TROUBLESHOOTING
523232
.0 Maximum pressure exceeded
1. Relieve pressure from system.
2. Check that the correct transducer type was
selected in Pressure Setup.
.1
System pressure not
detectable.
1. Activate product pump.
2. Check for system leaks.
3. Increase pump output to maintain a boom
pressure above 2 PSI [13.8 kPa].
.4
Pressure transducer not
detected
1. Check the pressure transducer connection.
2. Check the transducer cabling for damage and
replace the cable if necessary.
.15
Monitored system pressure
higher than maximum
pressure set-point
1. Reduce the equipment speed.
2. Refer to the
Pressure Setup section on
page 30 for assistance with adjusting the
maximum pressure set-point.
.16
Monitored system pressure
higher than the target
pressure deadband
1. Reduce the equipment speed.
2. Refer to the
Status and Control Inputs section
on page 46 for assistance with setting or
adjusting the target pressure.
3. Refer to the Alarm Settings Tab section on
page 36 for assistance with setting or
adjusting the off pressure percent.
.17
Monitored system pressure
lower than minimum pressure
set-point
1. Increase the equipment speed.
2. Refer to the
Pressure Setup section on
page 30 for assistance with adjusting the
minimum pressure set-point.
.18
Monitored system pressure
lower than the target pressure
deadband
1. Increase the equipment speed.
2. Refer to the
Status and Control Inputs section
on page 46 for assistance with setting or
adjusting the target pressure.
3. Refer to the Alarm Settings Tab section on
page 36 for assistance with setting or
adjusting the off pressure percent.
4305 .2
Equipment speed is below
operational range
1. Increase vehicle speed.
Code ID Description Recommended Actions