Raven RCM-Sprayer Hawkeye 2, Calibration And Operation Manual

Page: 39 / 124

4
System Setup: System Settings Tab 29
SYSTEM SETUP
FIGURE 2. Display Setup Page
5. Use the Tab Selection buttons starting in the upper, left area of the Display Setup page to select which Home
page tab to customize.
6. Next, select the readout area and use the drop down list to set the readout to display in the selected area.
7. Enable the Analog Gauges option to toggle product information on the rate control tabs as gauges.
8. Touch the Accept button in the lower, right corner of the page to accept the current readout selections and
return to the System Settings tab.
READOUT DESCRIPTIONS
No Readout. Select the No Readout option to leave the selected area empty.
Area per Hour. Uses the implement width and current implement speed to calculate the rate at
which field area is covered.
Area Remaining. The field area remaining for the current job in progress.
Boom Pressure. Monitored pressure of the spray boom.
Sparge Pressure. The current pressure of the sparge or tank agitation system.
PWM Readout. The control duty cycle of the PWM control valve which controls the product
pump.
Speed Readout. The current speed over ground of the machine.
Recommended Speed. The optimal speed range to maintain the target rate and pressure
settings. If the equipment speed is outside of the optimal speed range, an alarm condition may
be encountered and the control system may be unable to maintain the desired application rate
or pressure.
Selected Home
Page Tab
Select the
Pressure Tab
Customizable
Readout Area
Selected Readout
Area