Raven Hawkeye, Installation Manual

Page: 33 / 54

5
P/N 016-0171-655 Rev. D 29
ISOBUS ECU MOUNTING AND CONNECTION
ECU ELECTRICAL CONNECTIONS
NODE BULKHEAD CABLE INSTALLATION (115-7303-309 CABLE)
1. Locate the large, round receptacle on the Hawkeye
®
retrofit cable (P/N 115-7303-309).
2. Remove the nut and washer from the receptacle.
3. Feed the receptacle through the hole previously drilled through the back of the electrical box (refer to Figure 5
on page 28).
4. Replace the washer and nut onto the connector from the back of the electrical box to secure the receptacle.
5. Route the opposite end of the cable harness to the product controller II ECU.
6. Insert the black 12-pin Deutsch plug into the Product Controller II ECU as shown inFigure 7 on page 29. Push
each connector in until both retaining clips lock into place.
FIGURE 7. Product Controller II ECU Connections
Gray Green Brown Black