PAGE 20/30 |
Installation manual
|
016-5035-065EN
|
Rev.
Raven Industries Inc.
STEERING SYSTEM INSTALLATION | RAVEN EUROPE KIT INSTALLATION MTZ - BELARUS
Method of mounting:
•
Install the wheel angle sensor to the plate.
•
Mount the plate with WAS to the front axle
(Figure 21, Figure 22).
•
Ball Linear Sensor Mounts Installation, (p/n
117-8000-546):
o
Cut the threaded rod to measure.
o
Install one hex nut, nylock, din985 (p/n
312-6001-001) and one angle joint, m8,
radial (p/n 321-8000-001) on each end
of the was threaded rod, m8x210 (p/n
311-8000-004) (Figure 25).
•
Insert the bolt of the angle joint (p/n 321-
8000-001) through the center hole in the WAS
rod mounting bracket. Install one hex nut,
nylock, din985 (p/n 312-6001-001) on bolt of
the angle joint.
•
Insert the second bolt of the angle joint (p/n
321-8000-001) through the center hole in the
bracket, plate, U-bolt (p/n 107-0172-715)
.
•
Remove the nuts and clamp from the U-bolt
muffler clamp (P/N 311-9000-022) and install
the U-bolt around the tie rod with the legs of
the U-bolt pointing up.
•
Reinstall the clamp on the legs of the U-bolt
(Figure 27).
•
Insert the legs of the installed U-bolt through
the holes in the bracket, plate, U-bolt (P/N
107-0172-715).
•
Secure the bracket, plate, U-bolt (P/N 107-
0172-715) to the exhaust clamp using two
nylon insert lock nuts.
•
After mounting check the mechanism by
steering fully left and right.
o
FIGURE 25 SENSOR WITH BRACKETS
FIGURE 26 BRACKET, PLATE, U-BOLT
FIGURE 27 EXHAUST CLAMP INSTALLED
