Raven Case IH SmartTrax SPX 3230, Installation Manual

Page: 24 / 36

Chapter 4
20 Case IH SPX 3230, 3320, and 3330 SmarTrax™ Installation Manual
1.
Install the two large, rectangular connectors of the node cable (P/N 115-4001-110) into the correct ports of
the node, tightening the bolts on the harness connectors to secure the connections.
FIGURE 6.
CAN Connector Installed on Machine’s CAN System
2.
Connect the CAN connector to the machine’s existing CAN system.
3.
Connect the round 3-pin power connector of the node cable into the convenience power port on the
instructional seat.
Note:
High current power, which is used to run the steering operations, should be connected to a power
source separate from logic power, which is used to facilitate processing and communication
between the node and the console.
4.
Connect the DGPS connector to the GPS receiver.
FIGURE 7.
DGPS OUT Connector Routed Under Operator’s Seat
5.
Route the DGPS OUT connector out the right corner of the operator’s seat base and under the right arm
rest.