Ravelli RBH 150 V, Manual

Page: 100 / 276

Use and maintenance manual RBH 150 V - RBH 200 V
Pag.44
Rev.2 14/01/2021
ANOMALIA DESCRIZIONE
RD SYSTEM REGULATION
REQUEST
(only if the RDS system is
installed)
It shows that the testing procedure and initial parameter calibration have been completed
incorrectly.
This indication, however, does not block the stove.
FLOW METER FAILURE
(only if the RDS system is
installed)
It shows a failure of the air flow meter and the stove switches to minimum capacity
disabling the RDS system.
SERVICE REQUEST
The threshold value of set work hours has been reached. The symbol displayed remains
active throughout the work phase. Non-routine maintenance is required on the stove.
Warning Pop-Up
PHASE DESCRIPTION
OFF The stove is off
WAIT FOR PELLETS
OUT OF
When the switch-on request from ECO-STOP mode coincides with an automatic switch-off
condition (from the TIMER), the stove turns on ensuring total cleaning of the brazier before
switching to FINAL CLEANING.
INFEED SCREW
OVERFLOW
CONDITION: when the pellet setting (set p5) is near the continuous load condition.
SOLUTION: Set the value back to 0.
GENERIC ALARM The stove is in alarm state; refer to the troubleshooting chapter.
ANOMALY (general) The stove has detected an anomaly; refer to the troubleshooting chapter.
STAND BY
Forced shutdown state when the boiler water reaches 85°C. The stove restarts automatical-
ly if the restart conditions are met.
REASON SOLUTION
• The door and the ash box are not closed correctly • Make sure they are closed properly.
• Poor combustion in grate. • Switch off the stove, clean the brazier and check the cleanliness of the
support bench, clean the tube bundle by activating the turbolators and adjust
the combustion through pellet/air settings.
• Presence of foreign body in air intake tube. • Check if present and remove foreign body
• The air flow meter may be dirty. • Clean the flow meter with the stove in “Switched off” state
• Contact the Support Service
SIGNALLING
CLEAN
THE GRATE
(only if the RDS
system is installed)
La comparsa del messaggio “REGOLARE SISTEMA RDS” indica che la procedura di collaudo e taratura dei parametri
iniziale non è stata effettuata correttamente. Questa indicazione non implica il blocco della termostufa.
Adjust RDS
system