Use and maintenance manual Magnus
Pag.67
Rev.1 21/04/2021
Problem
Causes
Possible remedies
Alarm signal
No communication
between the stove
and the remote
control
Remote control not associated
with the stove
Pair the remote control to the stove following
the instructions given here
Radio interference
Evaluate the presence of other radio devices
in the vicinity
Remote control firmware not
compatible with stove firmware
(“LINK” message appears on
the display)
Contact the technical assistance service to
update the remote control FIRMWARE
Communication component
of the card or remote control
faulty
Replace electronic card or remote control
The remote control
does not work
Remote control battery low
Replace battery or connection to the stove via
cable
Faulty remote control
Replace remote control
The stove always
works at maximum
power
Temperature not set correctly
Set the remote control temperature again
Remote control position not
optimal for detecting room
temperature
Place the remote control in another location
Additional temperature probe
or external thermostat (if pres-
ent) faulty
Check probe or thermostat and replace if
necessary
Defective or broken remote
control
Check the remote control and replace if nec-
essary
The stove does not
turn on
Lack of electricity
Check that the power plug is inserted and the
switch in the “I / ON” position.
Fuse tripped following a fault
Replace the fuse with one having the same
characteristics (5x20 mm T 3.15A)
Clogged exhaust or smoke
duct.
Clean the smoke outlet and / or the smoke
duct