37
Notes for Ninja Quad Steps:
1. Inflate the base to the
recommended psi (2.3 psi),
then inflate each disc step
separately to the
recommended psi (5 psi).
2. Inflate corner step to 5-8 psi.
3. Install corner step:
a. Set step on ground (or at
water line) and push
tightly into corner of base
tube as shown.
b. Fasten both Velcro step
tabs under the Velcro
flaps on base tube.
NOTE: When properly installed:
•
There should be no gap between step and base tube
•
Velcro step tabs should be wrapping tightly around the
surface of base tube.
•
Velcro flaps are securely fastened over entire Velcro surface
of step tabs.
