Rauch QUANTRON-A, Instruction Manual

Page: 102 / 120

Spreading operation using the QUANTRON-A control unit 5
96
7. Wait until the progress bar has entirely run through.
 Idle measurement is finished
 Idle time is reset to 20 min.
8. Press the Start/Stop key.
 The spreading starts.
As long as the PTO is operating, a new idle measurement will automatically start
after the expiration of the idle time every 20 minutes.
Under certain conditions, an idle measurement is required to capture new
reference data before you continue spreading.
As soon as an idle measurement during spreading is required, the information
screen will appear.
In the event of unusual flow factor changes, the idle measurement must be
started
manually .
Precondition:

Spreading is stopped (Start/Stop key or both section widths deactivated).

The operating screen is displayed.

The PTO speed is at least 360 rpm.
1. Press the enter key .
 The display shows the idle measurement screen.
 The idle measurement starts.
2. Adjust the PTO speed, if necessary.
 The bar shows the progress.
NOTICE
As soon as the metering slides close (e.g. in the headland or by pressing the
Start/Stop key), the M EMC function will start an idle measurement in the
background (without information screen).

To this end, the PTO speed must remain at the preset value during the idle
measurement!
NOTICE
If you wish to observe the time until the next idle measurement, you can assign
idle time to the freely selectable display fields on the operating screen, see
chapter 4.10.2: Display configuration, page 76 .
NOTICE
A new idle measurement is mandatory when starting the disc and changing the
PTO speed and spreading disc type!