Service manual
AXIS H-EMC/ AXIS H-EMC + W
Implement ECU software update as of
SW 3.00.00
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 [email protected]
Page
6
of
16
Update SW
3.00.00
27/08/14
Chapter 411
4.5 The end of transmission is indicated.
Switch off the ISOBUS terminal
Disconnect the update cable from the PG update interface at the
cable harness
Disconnect the ISOBUS device plug and plug it in again
Start the ISOBUS terminal => after approx. 20 seconds, the spreader is loaded. If
the error message below appears, acknowledge the error message.
(CCI: acknowledge with the button)
