AXIS-H EMC
Alarm messages
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: [email protected]
Page
2
of
3
29.10.2014
Chapter 710
No.
Message in display
Meaning and possible cause
18
Blockade in drop point
setting.
The actuator for the drop point setting
cannot reach the set value it is to be
moved to.
Blockade
No position message
Calibration test
19
Defective drop point setting.
The actuator for the drop point setting
cannot reach the set value it is to be
moved to.
No position message
20
Error regarding LIN-Bus
participant: Name.
Communication problem.
Defective cable
Loose plug connector
21
Spreader overloaded.
For weighing spreader only
: Mineral
fertiliser spreader is overstrained.
Too much fertiliser in the hopper
22
Unknown status Function
Stop.
Communication problem at Terminal.
possible software error
27
spreading discs rotate
without activation.
Defective or manually switched hydraulic
valve.
28
spreading discs could not be
started.
spreading discs do not rotate.
Blockade
No position message
29
Agitator engine is
overstrained.
Agitator is blocked.
Blockade
Defective connection
30
Before opening the slides, the
spreading discs must be
activated.
Correct software operation.
Start spreading discs
Open metering slider
33
Stop spreading discs and
close metering slides.
You may only change into the system / test
menu area if the spreading mode has been
deactivated.
Stop spreading discs
Close the metering slider
